Toyota Camry manual transmission new in 2017 – 2018

Posted on

Toyota Camry manual transmission new in 2017 – 2018

Toyota Camrys with 4-cylinder or V6 engines only come with a 6-speed automatic transmission. The Camry Hybrid has a continuously variable transmission (CVT) to make the most of the gasoline engine and electric motor. The 5-speed manual transmission that was offered in previous years is no longer available. Toyota said there were not enough consumers interested.

Some models are available with shift paddles mounted on the steering wheel for those who still want to choose their own gears. By uraca, October 3, 2005, in General Toyota Discussions The manual transmission oil change has been made for the first time. Get data from the Haynes repair manual to use API GL-5 75-90 w gear oil. Found it in the Advance Spare Parts Store in quarterback containers. Triggered the car and used Jack stands. Slipped under the car and not finding a drain plug or filling / checking.

Take the lid on the left side to get a better view of the transmission. It has about 6 small bolts (10 mm) and two screws. The screws come out of a plastic holder and the bolts of the nuts held in place. Would you note what came from what hole. Used a six-inch extension on the ratchet to remove some of these. Still could not find any drain or fill / control plugs even after checking out Haynes. I went to the Toyota Repain manual and found the plugs shown in a diagram in the transaxle section. The plugs are 24 mm hexagonal.

The filling and check plug is located at the front of the car and the drain is on the left side. It did not seem to me that the corks were well separated vertically. Maybe 1.5 . Have a 24 mm Sears plug for about $ 4.00. Disconnected the filler plug / check and had some fluid. Let me know it was full. Reconnect this and remove the drain plug. Plastic bottles are too large for space to be able to eject directly. Get an Advance Auto funnel with a calibrated cup on top and about 18 inches of tube down. Can push the tube behind the radiator and stick the end into the filling / check hole. Assumed to fill until the fluid starts to come out or about 2.7 liters.

Move the drain pan under the filling hole and put the first two quarters in very quickly. Passed more slowly by adding the last part, leaving the tube cleared before adding more to the funnel. When he started to overturn, pulled the tube and dropped it into the drain pan. Put the plug in and tighten. We have not seen a couple for these cards, which is enough to tighten them. The delays in time were obtained to get the 24 mm grip – get the short grip – and to get the funnel with the tube. Also tried a suction pump, but it was defective and would not suck.

The funnel worked well and quickly and it was cheaper. It seemed stupid to have to remove the skirting boards to go to the drain and fill / check the records, but I could not find it any other way. It’s really a quick enough job to undo the bolts and screws and to put the cutting board next to it. In Car Talk’s website, you will recommend to your employees to do this work. They said they can do a better job of rinsing the transmission. Maybe, but it was a fun job if you just want to play with your tools. I should have mentioned that the car is 2001 Corolla this. You ended up doing the job the right way. Despite several trips to Advance and Sears. Trial and error, as they say.

My only question is whether you have used /semi-synthetic gear oil? Triggered the car and used Jack stands. Slipped under the car and not finding a drain plug or filling / checking. Take the lid on the left side to get a better view of the transmission. It has about 6 small bolts (10 mm) and two screws. The screws come out of a plastic holder and the bolts of the nuts held in place. Would you note what came from what hole. Used a six-inch extension on the ratchet to remove some of these. Still could not find any drain or fill / control plugs even after checking out Haynes. I went to the Toyota Repain manual and found the plugs shown in a diagram in the transaxle section.

The plugs are 24 mm hexagonal. The filling and check plug is located at the front of the car and the drain is on the left side. It did not seem to me that the corks were well separated vertically. Maybe 1.5 . Have a 24 mm Sears plug for about $ 4.00. Disconnected the filler plug / check and had some fluid. Let me know it was full. Reconnect this and remove the drain plug. Plastic bottles are too large for space to be able to eject directly. Get an Advance Auto funnel with a calibrated cup on top and about 18 inches of tube down. Can push the tube behind the radiator and stick the end into the filling / check hole. Assumed to fill until the fluid starts to come out or about 2.7 liters. Move the drain pan under the filling hole and put the first two quarters in very quickly. Passed more slowly by adding the last part, leaving the tube cleared before adding more to the funnel.

Toyota Camry manual transmission new in 2017 – 2018